Optical Modules & Parts

Sort By:  
Agilent 86106B 10Gb/s Reference Receiver (86106B)
The 86106B has an integrated, calibrated optical channel with a built-in OC-192/STM-64 filter that can be switched in for a standards-base transmitter compliance test. When the filter is switched out, the 86106B offers 28 GHz of unfiltered optical bandwidth for accurate characterization of high-speed lasers. The frequency-response variation of the unfiltered optical channel also has been improved to minimize the distortion on measured optical pulses. A 40 GHz electrical channel is available for wide-bandwidth measurements on electrical waveforms. 25 GHz optical channel for 9/125 fibers Wavelength range: 1000-1600 nm Characteristic rms noise: 10 uW (22 GHz BW), 18 uW (28 GHz BW) Maximum average input power: 2 mW Reference receiver capability (9.953/10.3125/10.664/10.709 Gb/s) 40 GHz electrical channel with 2.4 mm male input Characteristic rms noise: 0.25 mV (18 GHz BW), 0.5 mV (40 GHz BW) Maximum input signal: +/- 2 Vdc Compatibility 86100C Infiniium DCA-J Mainframe 86100D Infiniium DCA-X Mainframe
Pre-used in good condition.
0₪
Agilent 86109A 30GHz Optical module (86109A )
The 86109A provides the widest bandwidth for measurements of very high-speed optical waveforms. The integrated, calibrated optical receiver allows for easy, precise analysis of optical signals. The flat frequency response provides low-distortion, high-fidelity measurements. An average power meter is built in. The companion electrical channel has over 40 GHz bandwidth. 30 GHz amplified optical channel for 9/125 fibers Wavelength range: 1000-1600 nm Characteristic RMS noise: 15 uW (30 GHz BW) Maximum average input power: 2 mW 40 GHz electrical channel with 3.5 mm male input Characteristic RMS noise: 0.25 mV (18 GHz BW), 0.5 mV (40 GHz BW) Maximum input signal: ± 2 Vdc Compatibility 86100A/B Infiniium DCA Mainframes 86100C Infiniium DCA-J Mainframe 86100D Infiniium DCA-X Mainframe
Pre-used item in good condition.
0₪
Tektronix 80A06 Pattern Sync Trigger Module (80A06 )
PatternSync Trigger Module for the TDS/CSA8000 Series Sampling Oscilloscope 80A06 PatternSync Trigger module is required for the DSA8200 Series when using 80SJNB advanced Jitter, Noise, and BER Analysis software package. When this module is used with the 82A04 Phase Reference module, the jitter floor is =200 fsRMS. The PatternSync Trigger Module is programmable to pattern lengths of up to 223 bits and accepts a user-supplied clock signal from 150 MHz to 12.75 GHz. The DSA8200 UI/PI for the 80A06 module offers pattern lengths from 2 to 223 bits and programs the module to within it's hardware range (a prescaler followed by a counter with minimum count of 30) for the least-common-multiple count.
Pre-owned in good condition.
0₪
Per Page      1 - 4 of 4
  • 1